B6100 oil overfilled

  1. Either way, the correct amount you should use is where the dipstick reads at the correct height. I'd drain some out to get that level. The reason you didn't get every oz out was because some is stuck in the oil pan, glazing all the parts etc. Don't put the whole 4.1 back in when you change oil just put maybe 3.75 and then look at the dip stick and add a little bit, measure and repeat giving maybe 30 seconds for it to settle. Then when your done, check again after it sits if you are worried about the fill. A little bit over or under is ok but 3/4 inch high is becoming too overfilled.

Leave a Reply

Your email address will not be published. Required fields are marked *

Author: admin