And so a new Journey......Begins!

  1. When I print resin I always use my mercury cleaning setup from Elegoo then right out of an IPA bath they go to hot water let sit for 3 to 5 mins and remove supports submerged! Normally you won't get a mark on your mini if you do that or at least I don't if it's very thin parts I cut off at the support and remove after the hot water so it doesn't snap. If anything left over I give it a light sand and then return to IPA for a final bath before priming.

Leave a Reply

Your email address will not be published. Required fields are marked *

Author: admin