I bought this car a few years back and the scoop does not have a grille in it, what would be the proper way to go about attaching one without using rivets and similar methods. It is a fiberglass hood. Any good videos or resources you can recommend?

  1. That’s pretty close actually. You can use chicken wire or universal bumper grille products you can get at auto zone. Then a panel bond, super glue, fiberglass, or strong thick adhesive that will stick to fiberglass.

  2. Id say epoxy. Tape the grill where and how you want it, then epoxy the edge to hold it in place.

  3. I’d try 3m adhesive/ tape. All the new badges on my car are just held in by 3m but it’s super strong

Leave a Reply

Your email address will not be published. Required fields are marked *

Author: admin